Description

I would like to share and discuss about Engineering Subjects, Technical Seminars, Softwares Explantion and General Knowledge Discussions in this Blog.

Tuesday, 1 October 2019

Experiment No: 4 - Electronic Workshop Lab

Experiment No: 4
Testing of electronic components like Resistor, Capacitor, Diode, Transistor, ICs etc.

● Compare values of components like Resistors, Inductors, Capacitors etc with the measured values by using electronic instruments.

Aim:
A) Test the electronic components like Resistor, Capacitor, and Inductor by using the electronic instruments.
B)   Compare values of components like resistors, inductors, and capacitors with the measured values by using electronic instruments.
C)  Test the electronic components like Diode, and Transistor, ICs by using the electronic instruments.

Components and Equipments Required:

S.NO
Components / Equipments
Range
Quantity
1



2



3



4



5



6



7



8



9



10



  Procedure
1. Testing the resistor value using Multimeter and compare the theoretical value using color band.
2. Testing the Capacitor value using Multimeter and compare the theoretical value.
3. Diode anode terminal is connected to the Multimeter's Positive end and Diode cathode terminal is connected to the Multimeter's negative end then find the value, where as Multimeter keeping as Diode mode.  
4. Repeat the same procedure to all the components. 
5. Note down the corresponding values and tabulated of different values.   



Tabular Forms:
S.NO
COMPONENT NAME
PRACTICAL
VALUE
THEORETICAL VALUE



















Precautions: 
1. Connections are made as per the circuit diagram and should be tight.
2. Do not connect power to a circuit until the circuit is finished and never work on a circuit while power is applied.
3. If anything is burning, immediately disconnect the power and examine your circuit to find out the problem.

Outcomes:



Result:

No comments:

Post a Comment